Brick LEG0 logo Lightbox

Dimensions: 21 x 21 x 5 cm 8.3 x 8.3 x 2 inch (length, height, depth)

Print Settings:

Use standard setting .20mm Layers + Only one wall on first layer + AUX OFF

No Supports

You need a classic 5 meter long LED strip (the one I used is 12 mm wide). You can use aluminum adhesive tape to stick on the rear panel for greater adhesion of the strip and color uniformity. Or you can glue kitchen aluminum foil, or even without it.

Start gluing the strip from the lower edge where there is a hole on the rear panel for the power supply (diameter 5 mm, if your cable is smaller it is sufficient to wrap a bit of adhesive tape around the cable near the hole so that no light comes out, if it is larger use a drill or soldering iron to enlarge the hole as desired). Perform 90 degree bends without forcing the LED strip too much.

When there is no more space left, proceed with the lateral edge of the lightbox, partially overlapping the LED strip in the windings in order to save more space.

I recommend leaving about 1 centimeter from the white wall of the internal lightbox to have a homogeneous result, without seeing the bright points of the strip.

In doing so I managed to use all 5 meters of LED strip.

Add glue to the shoulder of the lightbox and place the rear cover