Marshall Mini Stack Money Box

Features:

• A Scale Replica Of A Marshall JCM800 Head And Cab
• Coin/Note Slot In The Top
• Large Internal Capacity
• Removable Rear Access Cover
• A Great Piece For Any Musician Or Music Lover!

I have separated this model into separate print profiles for easy printing. This will save you having to adjust settings within Bambu Studio when using a 0.2mm nozzle. The only thing you need to do is physically swap nozzle and change the nozzle type on the printer itself :)

Assembly:

• All parts must be glued together. It requires the smallest amount of glue to hold the parts in place, so be cautious not to use too much.
• The logos have a recessed impression in the speaker grills of the main body, for easy alignment.
• There are 2 rear covers included. One has some small ridges to help with removal and one is smooth. You don't need both but may have a preference between the two.

• The rear access cover just slides in place from the bottom with a dove tail type joint. Ensure it is the right way up though (The bottom edge has a more rounded profile)

Extra Info:

• The front panel and white edging strips must be printed with a 0.2mm nozzle to retain as much quality as possible. At this scale the text is barely readable, but does still give the desired effect. You can of course scale the amp up enough to retain all of the text if you want to :)

• The main body will print with no support (The example print was printed this way) BUT this does require two 80mm un-supported bridges and some clean up with a sharp craft knife post print. This is in order to get a nice fit with the edging strips.

Please rate and review your printing experience

Don't forget to add a picture of your amp to the comments below :P

Thanks for looking!