Update:

So far thanks everyone for trying. This model is definitely not an easy model to print.

- Adhesion: in my case I need to use glue but brim should serve the purpose too.

- Speed vs quality: you may want to go slower

===
A minimalist avocado starter with diamond pattern.

Original dimension is approximately 80mm in diameter and 18mm height.

Sample in the photo is printed with Sunlu matte white PLA.

Consider it as a print challenge model. This isn't an easy print, and it may not turn out very neat.

I've managed to print with following parameters:

• X1C 0.4mm nozzle
• Cool plate + glue / or brim
• 0.08mm layer height
  • the slicer does not deploy support with this setting with Tree Hybrid support + Support critical region only turned on.
• Gyroid infill as always
• 2 walls