This is a Thermal Switch Setup to turn on Bento Box 2 air purifying system at a given temperature and turn off at a different temperature. The model is the box holds a XH-W3001 Thermostat Switch and has two 10mm x 5 mm cylindrical magnets to hold it to one side of your enclosed Bambulab 3D printer.

Parts Used in this Setup:

• This makerworld model.
• XH-W3001 Thermostat Switch (12V)
• Pigtail Barrel Connectors
• Additional 18 gauge cable
• Seal wire connectors
• 10 x 5 mm cylindrical magnets
• Bentobox 2.0 or 1.0 (I purchased mine as a kit)

Setup:

• See instructions for XH-W3001 for connections for 12V setup
• Print my model
• The parts provided above should be all you need

How to Use:

• I have mine setup now at 45°C to start and 28°C to end. The idea is that when the your machine enclosure reaches a certain temperature, the bento box will start, and a while after it cools down, your air filtering stops. You could set the start temperature for example much higher, so that for example, your bento box filter only works when you are doing ABS / ASA / PC and not when doing PLA / PETG.