Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Simple screwable easter egg. Perfect for small objects to hide for the easter season.
The inside is hollow with a minimum diameter of about 3 cm / 1,18 in at the center. In the top and bottom half the diameter gets a bit bigger after the thread. The first screws are a bit stiff but after a few times it should open and close smoothly.
Size:
- Height: about 7 cm / 2,75 in
- Width: about 5 cm / 1,97 in
Material: I printed this in PLA and it worked perfectly fine, other materials should work as well but are not tested so far
Support: Yes, you can customize the support structure if you want however I found the default support to be working just fine.
Printer Settings:
- Layer Hight: 0,2 mm
- Layer Width: 0,4 mm
