Chamber heater PSU + temp controller case

I made this case for the Meanwell LRS-350 (works for LRS-200 as well) power supply and STC-1000 temp controller for a chamber heater for the X1/P1. It will of course work with any other chamber heater or as a general PSU enclosure.

PTC heater holder: [https://makerworld.com/en/models/372101](https://makerworld.com/en/models/372101)

It has a cutout of the AC power plug and switch, a DC barrel plug as well as a hole to pass throgh the temp sensor. The PSU can just attach to the bottom of the case via some double sided nano tape. There is a hole in the bottom back of X1/P1 that you can fish the wires through without any cutting, crimping or soldering them after pulling them through. M4 screws to fix the lid to the body.

Meanwell LRS-350-24v: [https://a.aliexpress.com/_mOqtUxD](https://a.aliexpress.com/_mOqtUxD)

STC-1000 temp controller, you need the 24v version: [https://a.aliexpress.com/_mNKCdOT](https://a.aliexpress.com/_mNKCdOT)

200w PTC heater, again the 24v version: [https://a.aliexpress.com/_mPJSRgP](https://a.aliexpress.com/_mPJSRgP)

AC plug and switch: model AC-04C [https://www.aliexpress.com/item/1005006361356458.html](https://www.aliexpress.com/item/1005006361356458.html) also I just super glued it in instead of using the screw attachments.

DC barrel female jack, 5.5x2.1mm [https://a.aliexpress.com/_mMBGOt2](https://a.aliexpress.com/_mMBGOt2)

DC barrel male plug, 5.5x2.1mm 18AWG [https://a.aliexpress.com/_mr0JIH1](https://a.aliexpress.com/_mr0JIH1)

Should be printed with no supports and with the AUX fan completely off to avoid warping.

Descrição