The Complete Seed Starter Kit - Just Add Soil, Seeds And Water!

Features:

• 9 pot seed tray
• Self watering, levee style hydration system
• Translucent pyramid lid to create a mini greenhouse. Perfect for more exotic seeds!
• Great for windowsills, balcony's and porches
• Designed to use minimal filament - 9 Pot Tray = 87g - Pyramid Lid = 47g - Base = 128g
• Easy to print with no support or AMS needed
• Split into 3 plates that can be printed on any Bambu Lab printer (Including A1 Mini)

Usage:

• Fill the base' with water so that all squares are equal.

• Place your filled seed tray on top of the base

• Place the pyramid lid on top of the seed tray ensuring it is fully seated in the groove

• Then

Extra Info:

• The ‘Base’ is sliced in a way that should be water tight (up to 6mm high) - So far all of my tests have held water fine.
• Do not over fill the base with water as this will make a mess when adding the seed tray.
• Place the seed starter kit on a level surface. This is crucial for the watering system to function correctly.
• The translucent pyramid lid in the photo examples was printed in clear PETG - Plate 2 is set up for this, so please edit the filament type if you are using a different material.
• The seed trays and the pyramid lid are designed to be no more than 2 walls thick. This allows light to penetrate the pyramid and also helps with the removal of the root block, as the individual pots can be deformed with a squeeze.
• Printing the pyramid with a brim is essential as the 1st layer contact area is very small and will try to warp without one.
• Clean up any brim material left on the pyramid with a de-burr tool or sharp craft knife. This edge needs to be clean in order to fit in the slot located in the seed tray.
• Ignore the ‘floating regions’ warning in Bambu Studio. This is purely related the tray slot which will bridge, absolutely fine.

Thanks for looking!

If you have any ideas for improvement, please leave a comment below :)

Please rate and review your printing experience :P