The filament clip reinvented!  耗材夹

Advantages:

- The CLAW clip is the fastest and easiest universal clip to use. Thanks to its clamping mechanism, it effortlessly grabs onto the support filament loop and keeps a tight grip.

- An innovative design that allows it to be used on completely full and empty spools.

-Fast and Easy to print. No supports, brims, or overhangs.

If you prefer a clip that attaches to the edge of a roll check out my other solution below:

[https://makerworld.com/en/models/679595#profileId-607843](https://makerworld.com/en/models/679595#profileId-607843)

Version 2

I've modified the hole to be a square now so the chances of a hole blockage are reduced.

Improved SLICER settings:

“Seam position” set to “Nearest,” so back-to-back seams do not drip and block the clip holes.

“Order of walls” set to "outer/inner" so the extruder prints other areas of the clip before printing the hole perimeter. I've found that this setting stops the holes from being blocked by overextruded material.

***If you use PLA and the spring back function it’s gone; you can manually pry open the clip to recover the spring effect****

THANKS FOR PRINTING!!!