A little tool to make it easier for you to paint the Easter eggs.

An egg can be clamped between the two holders using the rubber band. The distance can then be optionally fixed with the screw. By turning the handle, the egg can be painted from all sides without getting dirty fingers.

Additionally you need:

• 1x Rubber band
• 2x 608Z bearing (3D printed ones should work as well)
• (optional) 1x M5x15 Screw
• (optional) 1x M5 Nut

To print:

• 1x mainmount_new
• 1x moveablemount
• 2x handle
• 2x eggholder

Instructions:

1. Put bearings into the mainmount_new and moveablemount
2. Insert eggholder and secure other side with handle. Should be a friction fit, otherwise use glue
3. Insert moveablemount into mainmount_new
4. Span rubber into groves