After printing your mold, insert the wick into its joint, tighten the two pieces of the mold (with the help of a bench vise or clamps), and pour the melted wax.

After a few hours (when the wax is solid) your new candle will be ready.

I didn't use any type of lubricant, the wax came off the piece very easily.

To help you detach the two molds from each other, you can help yourself with a screwdriver by inserting it in the 2 holes on the side.

I tried printing this in PLA and it held up to temperatures, i recommend a fairly high filling.

Candle Diameter: 6cm