A simple wall mount/clip for the Infinity X1 flashlights

These are found at Costco, and there are multiple versions of the flashlight with different dimensions, so there's a clip designed for each one:

• 5000 Lumen
• 7000 Lumen
• There's also a 10,000 Lumen version I don't have yet, so I don't know it's dimensions

There's a single print profile here with each model on its own plate. Just print the one for your flashlight. If you happen to have both, there's an optional plate that has both models with labels embossed on them.

Mounting

All versions attach to a wall with 2 screws. The screw holes are a bit over 4mm in diameter, and fit #6 and #8 screws easily. The holes are countersunk, but also bored out a bit and seem to work well with the pan head screws I've tested. 

Note: mount to something sturdy, like wood or plywood. These flashlights are long and heavy. If you mount into something brittle, like drywall (without a stud) or plaster, it may break loose if you quickly grab the flashlight or if someone bumps into it.

Material and Print Settings

I've tested successfully in PLA and ASA. 

PLA should be fine for indoor use, but I'd recommend something more temp resistant if you're putting this in a garage, shed, etc.

Print settings are basic 0.20mm height with a couple modifiers: 4 walls, 25% Rectilinear sparse infill

Credit

This was designed completely from scratch using measurements of the flashlights I own. 

Feel free to remix, but not sell.