This is a mount and cord organizer for the Blink Sync Module 2 I deisnged in Fusion 360. I designed this to clean up my counter space and fit the plug, cord and sync module 2 all in one mount. To assemble this, insert the blink sync module 2 into the mount. Plug in the cord to the sync module and then put the extra cord into the back of the mount. Run the usb cord through the power plug mount from the rear to the front. Insert the power block into the mount and plug in the usb cord to the power block. Pull extra cord from the rear and put into the rear cord organizer compartment. Plug the sync module 2 into the wall.

This mount will be tight on the power block if you still have the clear protective film on it. It will be looser on the power block if you remove the clear protective film.

This model does not need supports to print.