Grumpy Cat Trinket Dish

A grumpy cat who probably doesn't want to hold your things... but does it anyway.

This trinket dish is designed to hold rings, earrings, keys, coins, crystals, dice, or any other small bits and pieces that usually end up scattered around your desk or bedside table. The detailed fur texture and permanently unimpressed face make it just as much a display piece as it is something useful.

The file comes in three sizes, so you can print one that best suits your space.

Sizes

Small

• 140 × 68.48 × 49.89 mm
• Dish opening: approximately 52 mm

Medium (shown in the listing photos)

• 170 × 83.25 × 60.58 mm
• Dish opening: approximately 62.6 mm
• Dish depth: approximately 33 mm

Large

• 200 × 97.83 × 71.27 mm
• Dish opening: approximately 71.3 mm

Recommended print settings

I recommend printing at 0.12 mm layer height to bring out the fur texture and facial details.

The model was designed using:

• 3 walls
• 15% Gyroid infill

Printed in PLA, these settings give a good balance between detail, strength and print time.

Supports recommended.

The model prints as a single piece, so there's no assembly needed.

Enjoy printing it, and if you do make one I'd love to see how it turns out.