Introducing the PrintCore SnapScrape. This isn’t just any old 3d printer scraper that you print, use, then throw away. This scraper has multipule features indluding, removable scraper, hook (for getting those horrible parts of filament off the bed or your models and also for slashing open those vacum sealed filament bags) and an 45 degree angled filament guide which alows you to cut your filament at exactly 45 degrees so that it slides through any hotend.

There are some imprtant steps which you should follow to get your SnapScrape scraper working properely...

Once you have removed your scraper from the printer, there are some supports which must be removed.

Here is some important considerations to help you assemble the scraper in the best way possible:

1. Please gently remove the supports inside the scraper body carefully making sure that you don’t damage it. You can use pliers to remove the biggest parts of support.

   

2. For the smallest support parts, make sure to use a knife to remove the supports with ease.

3. When removing the scraper blade supports make sure to be carful to remove the right parts.

   

4. It is recommended to carefully hit the main handle of the scraper with a hammer to help the two arts slip together. Repeat this carefully a few times until the blade slides in and out of the main scraper handle smoothly.

   

NOTE: This is version 1 of this scraper so if there is any problems then please comment below and suggest what the problem is and i will take note and use them to help improve version 2.