All of the prints I print to make sure they look good. Some of the times with hue forge they can come out a little discolored because of the transmission distance. I would strongly recommend the colors that I am using to really get the best effect.

They are 200x200 and fit standard frames. Allot of my prints are thicker and don’t really need a frame for them. I just usually print a hanging tab for the back and glue it on.

All instructions are included

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.64mm
The Max allowed Thickness is 2.64mm and the Actual Thickness is 2.64mm

    PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
    PLA BambuLab Basic Hot Pink  Transmission Distance: 3.9
    PLA BambuLab Basic Beige  Transmission Distance: 3.5
    PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
    PLA BambuLab Matte Sky Blue  Transmission Distance: 1.3
This print uses 5 unique filaments

Swap Instructions:
    Start with Charcoal
    At layer #9 (0.8mm) swap to Hot Pink
    At layer #16 (1.36mm) swap to Beige
    At layer #22 (1.84mm) swap to Ivory White
    At layer #24 (2mm) swap to Sky Blue
    At layer #27 (2.24mm) swap to Ivory White for the rest.