print with .2 mm layer height because i've designed it to be only one layer thick on the main body. prints in less than 8 minutes.

I've designed this to be modified off of print bed. you can easily cut it since its only .2mm thick which is about .008 of an inch. 

installation instructions

if you need it to be rounded simply get close to it with a lit flame, only need less than a second then put it on your phone or case and let it cool to the correct shape.

once cut to size and shaped you can use pure alcohol no water diluted alcohol (which isn't conductive and won't harm your electronics) to create adhesion against the phone case, and slide your phone towards the aux cover first then proceed on the other side.

when installing make sure the small extrusion is facing away from the phone. like shown in the pictures.

how to use slide able aux cover

use your nail to grip the small extrusion to slide it back and forth.

Please enjoy.

any all feedback is greatly appreciated.