Here is another 3d block for the item frame I designed, which is a grass block! This item uses two of the neodymium magnets, but I have also included two extra magnet holes if you wanted to use them as well (Check the bottom of the description for the link). The magnets are added after the print is finished, at the back where the hexagon shapes are and do not require any superglue to be held in place. Just be sure to insert the magnets in the right direction, so that the block attaches to the item frame correctly!

This model is support free and does require the AMS. While it does use the AMS, I do know that it should not waste much material. I would recommend that you print multiple blocks if you'd like to save as much filament as possible. For a dual extruder printer, there should be very minimal waste with the way I have it set up.

The three different filament colors/brands I used are:

Inland Brown PLA

El3goo Silver Rapid PLA+

Bambu Green PLA Basic

If using a dual extruder printer, I recommend having the brown filament in the left nozzle, and the green and silver filaments for the right nozzle.

The link for the magnets, and the item frame itself, can be found here:

[https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479](https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479)