All of the prints I print to make sure they look good. Some of the times with hue forge they can come out a little discolored because of the transmission distance. I would strongly recommend the colors that I am using to really get the best effect.

They are 200x200 and fit standard frames. Allot of my prints are thicker and don’t really need a frame for them. I just usually print a hanging tab for the back and glue it on.

All instructions are included

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.88mm
The Max allowed Thickness is 2.72mm and the Actual Thickness is 2.56mm

    PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
    PLA BambuLab Basic BambuLab Green  Transmission Distance: 2
    PLA BambuLab Matte Scarlet Red  Transmission Distance: 2
    PLA Kexcelled Skin  Transmission Distance: 4.4
    PLA BambuLab Basic Turquoise  Transmission Distance: 1.4
    PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
This print uses 6 unique filaments

Swap Instructions:
    Start with Charcoal
    At layer #13 (1.12mm) swap to BambuLab Green
    At layer #16 (1.36mm) swap to Scarlet Red
    At layer #18 (1.52mm) swap to Skin
    At layer #23 (1.92mm) swap to Turquoise
    At layer #27 (2.24mm) swap to Ivory White for the rest.