Predator Gym Bro

The only thing this predator is hunting is those sweet sweet gains! Modeled on the original predator, no mask obviously!

DO YOU LIKE A CHALLENGE??? - This NO AMS model will hit that sweet spot, with some teeth which will test your patience and glue strength! I have modeled the face to be seperated however installing those inner teeth can be a little fiddly. 

Model is large at roughly 28cm tall when complete!

INSTRUCTIONS:

• Install the yellow eyes into the black trapezoid shape to install the eys from the back of the head. This gives him a sunken eyes look.

   

• Install the red mouth peice, after this install the lower set of teeth first then the upper set, followed by a spot of glue for the outer fangs. 

   

• After glue has dried the hair can be fit onto the head, then everything else slots togther easily!

📌 Recommended printing settings:

• Material: PLA
• Layer height: 0.16 mm
• Infill: 15%
• Nozzle: 0.4mm

supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal

Assembly – Recommended Method on multipart models

• Dry fit: Assemble all parts without glue to check alignment and fit.
• Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together.
• Optional fix: Use glue for permanent assembly.