A 3D‑printed tablecloth weight that you simply fill with sand—no flimsy clips, no slipping, no fuss. The compact body hangs cleanly off the edge of the table, using real mass instead of weak spring tension, so it stays put even in gusty conditions. The non-slip grip locks tight onto the fabric and won't come loose. Just fill, put the cap on, and let gravity do the work. It’s tougher, smoother, and far more reliable than the old clip‑type solutions.

When filled with sand the weight is approximately 67 grams. Print four of them and attach one on each corner of the tablecloth.

The container part requires good adhesion so start with a clean print bed. If you have trouble printing the container, consider using an outside brim.