This is a button to go in the button hole in the frame of the BambuLab P1P. I have 2 different ways to print it so that people with and without an AMS can print it multicolored.

If you HAVE an AMS, select the 'With AMS' print Profile, and print as you would normally.

If you DO NOT have an AMS, print the ‘P1P Button Icon’ and when that finishes, print the ‘P1P Button Main’ Without removing the previous print. It will print over the top of it and the 2 prints will turn into 1.

DISCLAIMER:

Quite a few people have mistaken this for a cover for the hole in the top of the printer. This is designed to go on top of an actual button (mounted under the hole) that turns on custom LED strip lights that have been installed. It is meant to be able to fit inside the hole and fall through if there isn't anything underneath it. This is not meant to be a plug for the hole. If you are looking for a plug I have one here: [https://makerworld.com/en/models/36958#profileId-35275](https://makerworld.com/en/models/36958#profileId-35275)