About

A ground-up rebuild of the excellent Polymaker spool adapter with the following changes:

• Edge clips removed (These tend to damage spools and are also not needed since the adapter uses the locator pin to lock into place)
• The Center design has been updated for a more generic spool look (More visually compatible with both Polymaker and Overture brands)
• The fitting has been slightly adjusted to allow easier swapping between spools without compromising its hold on the spool (less likely to break when being removed)

Printing

Prints well in PLA and PETG. PETG is less brittle and has better layer adhesion, which is beneficial with the very thin edges (to help avoid layer splitting).

Remixing

This model can be remixed using the provided Onshape link or via your own tools using the provided Step file.