L from Death Note Hueforge

Project: L deathnote

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 159.94x239.91mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.07573mm

    #00358e PLA BambuLab Basic Blue Transmission Distance: 4
    #000000 PLA BambuLab Basic Black Transmission Distance: 0.6
    #4c5f71 PLA BambuLab Basic Blue Gray Transmission Distance: 3
    #ffffff PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Blue
    At layer #10 (0.88mm) swap to Black
    At layer #14 (1.2mm) swap to Blue Gray
    At layer #16 (1.36mm) swap to Jade White for the rest.

It might say you need supports but you don't

If you want to upscale, make sure to remember the z height, in this model it is 2.08, then rescale using the corners, then uncheck uniform scale
then set the z height to the Z height said above and thats it! If there is a thicker base version, then the Z height will be said in print profile description.

If you like my model, check out my account and see my other models!

Descrição