Raise tables, sofas, beds, or any furniture to the perfect height with this fully parametric riser. Designed to be customized through MakerLab so it fits your specific furniture leg — no need to search for a model that "almost" fits.

Features:

• 🔧 Fully customizable — adjust total height, pocket size, and base footprint to match your exact measurements
• 🔘 Round or rectangular — choose the shape that fits your furniture leg
• 🏗️ Stable design — wide, tapered base for a low center of gravity, even at greater heights
• 🖨️ No supports needed — prints straight off the plate, no cleanup required
• 📐 Smooth, rounded edges — clean look, no sharp corners

How to use:

1. Measure your furniture leg: width/diameter, and how deep the leg sits before it needs support
2. Decide how much height you need to add
3. Open the Customize in MakerLab button on this page and enter your measurements
4. Download your personalized STL and print

Recommended print settings:

• Material: PETG recommended for best load-bearing strength and resistance to deformation over time (PLA works for lighter use, but may slowly deform under sustained weight)
• Layer height: 0.2mm
• Walls: 4 loops
• Infill: 35–40%, gyroid pattern
• No supports required — print foot-down directly on the plate

Tip: For heavier furniture or warm rooms (e.g. near windows), PETG is strongly recommended over standard PLA, since PLA can slowly deform under constant load over weeks/months.