Leaf Pattern Pads & Swabs Holder

Leaf Pattern Pads & Swabs Holder — PLA Print Version

A decorative pads and swabs holder designed for direct PLA 3D printing.

This model features soft rounded forms, a matching tray base, and subtle leaf details, making it suitable for organizing cotton pads, cotton swabs, and small everyday essentials on a vanity table, bathroom shelf, or skincare station.

This version is intended to be used as a finished PLA print. It is not recommended for stone powder casting, plaster casting, or similar reproduction methods. During previous production tests, the stone powder cast broke while being removed from the silicone mold. Because of the form, recessed details, and edge transitions, this design should be printed directly and used as a PLA object rather than reproduced through casting.

For best results, print and use the model directly in PLA.

Recommended Use

Cotton pads holder
Cotton swabs holder
Vanity organizer
Bathroom shelf accessory
Skincare station organizer
Small daily-use storage

Material Recommendation

PLA is recommended for this version.

Important Note

This model is designed to work best as a direct 3D print.
A stone powder casting test was attempted, but the piece broke during demolding from the silicone mold.
For that reason, this version should be printed and used directly rather than cast.

Version Note

This is the original PLA print version of the Leaf Pattern Pads & Swabs Holder.
A refined version with further improvements will be shared separately.

Thanks.

Descrição

Recommended Use

Material Recommendation

Important Note

Version Note