Bring your EverBlock builds to life with this 2×2 Artificial Fire Module, designed to snap seamlessly into any EverBlock‑compatible layout. This piece creates the illusion of glowing embers or a flickering campfire using a geometric flame‑cut housing that diffuses LED light beautifully. Perfect for castle scenes, fantasy dioramas, tabletop setups, or ambient decorative builds.

The hex‑patterned shell softens the light while the stylized flame cutouts on top project a warm, ember‑like glow. Pair it with a small LED puck or tea‑light for a dramatic effect without heat, smoke, or wiring complexity.

Instructions:
 

• After printing the main block - run the USB cord through the center.  There is a notch on the side wall to allow cords to pass around the fan. 
• Put in the fan - it is a snug fit, so MAKE SURE IT IS BLOWING AIR UP (you don't want to have to remove it later)
• Run the LED's along the sides (I got a strip with adhesive tape)
• Tape strips of paper mache (or other light material) to the cover plate
• Put in HWS grids if you'd like (not necessary) 
• and…..Walla - artificial fire.  

I've still got a few improvements to make.