This bumper case is designed for the iPad mini 6 and iPad mini 7. 

 

The model was printed in PETG.

It provides edge protection while maintaining full compatibility with the Apple Pencil. The right side is intentionally left open, allowing the Pencil to attach magnetically for charging and pairing. 

The case also includes a small holder to help secure the Pencil tip.

 

Thin screen protectors should fit without any issues. 

If there is slight interference, gently pressing the edge of the case into place with your fingernail will usually help, and it tends to become less noticeable over time. 

I have not tested the case with tempered glass screen protectors, so compatibility is uncertain and may be limited.

 

Please be careful when removing the supports after printing. 

Removing them too forcefully could damage or break the model.

 

Thanks for checking out my design! I hope you enjoy it and find it useful.