Florena is a fluted planter with quiet, Scandinavian-inspired lines — fine vertical ribbing wrapping the upper body, a smooth lower band, and a soft rounded foot that lifts it just off the surface. It's designed as a clean, modern home for your plants that looks as good on a shelf as on a windowsill.

The model was built from the ground up to print beautifully: smooth surfaces of revolution (no faceting on the curves), a properly thick, rounded base, and walls tuned so the whole body prints as solid perimeters. No supports needed.

Dimensions

• Height: 150 mm
• Outer diameter: 160 mm (rim), body ~156 mm
• Inner opening: 150 mm · usable interior depth ~142 mm
• Wall: ~3 mm · solid base ~8 mm

Fit: This is a closed decorative pot (no drainage hole) — perfect as a cover pot. Drop in a nursery/grow pot up to ~14 cm and lift it out to water. Want drainage? It's easy to add a hole if you'd rather plant directly.

Recommended print settings (what I used)

• Nozzle: 0.4 mm · Layer height: 0.16 mm (0.25 mm initial)
• Walls: 2 loops · solid top & bottom
• Infill: 10% (the body is mostly perimeters anyway)
• Seam: Back · Smart scarf seam on (hides the seam on the fluted face)
• Elephant-foot compensation: ~0.15 mm · No supports
• Matte PLA recommended for the best ceramic-like finish

Print it, plant it, and enjoy. If you make one, I'd love to see it — drop a photo in the comments. 🌱