Cairn — a stacked-disc table lamp with a hand-molded clay inspired base, with a soft, warm glow. For use with E27 bulbs.

!!Base and Shade are Fully interchangeable with my Cascade Table Lamp!! [https://makerworld.com/en/models/2944794-cascade-table-lamp#profileId-3298591](https://makerworld.com/en/models/2944794-cascade-table-lamp#profileId-3298591) 

Additional hardware required: Cord (https://www.amazon.com/dp/B0FT7JXZXS/ref=twister_B0CTKLBZHX?_encoding=UTF8&th=1)

**Assembly**
- Screw the first threaded nut onto the cord base
- Push the cord base through the aligned holes for the shade and base
- Screw the second threaded nut on the opposite side of the cord base, and tighten both together until you have a snug fit

**Technical details**
- Dimensions: 5.3 inches wide × 13.2 inches tall (when fully assembled)
- Support-free
- Recommended bulb: E27 LED
- Includes 2 printed clamp nuts 

**Recommended print settings**
- Material: PETG
- Layer height: 0.2 mm  ·  Walls: 2  ·  Supports: none
- Infill: base 10-15%, shade 0% 
- Seam position: Back 

**⚠ Safety Warning — Please Read Before Printing or Installing**

- This model is designed for use as a decorative lamp. By downloading, printing, or installing this model, you accept full responsibility for its safe use.
- Not all filaments are suitable for use near heat sources. PLA has a low heat deflection temperature and is not recommended for enclosed or direct-contact lamp installations. Use heat-resistant materials such as PETG, ASA, or ABS. Good quality LED bulbs are strongly recommended — they run significantly cooler than incandescent or halogen alternatives.

**License**
Free for personal, non-commercial use under the Standard Digital File License. Please don't reshare, resell, or redistribute the files or prints. Want to sell physical prints? A commercial license is available through my MakerWorld membership.