A creative pixel art toy. Plug colored blocks into the baseplate to build any picture, then pull them out and start again.

Everything is parametric in the MakerWorld Customizer:

• Drawing: Mario, Heart, Mushroom, Dog, Controller, Cat
• Drawing scale: 1x or 2x
• Plate size: set width and depth separately (square or rectangular)
• Grid pitch, plate thickness, border: all adjustable
• Please note border width is not included in board size

How it works: each block has a clip peg that pushes through a square hole and grabs under the plate.

Render modes in the Customizer:

• baseplate: just the board
• demo: the selected drawing assembled on the board (preview)
• print: the board plus every block of the drawing, laid flat and grouped by color, ready to slice

Print settings

• Supports: NONE (the clip barb is angled at 45 degrees)
• Layer height: 0.2 mm
• Walls: 3 perimeters (blocks are small, more walls = stronger clips)
• Infill: 15 to 20%
• Material: PETG, do not use PLA pegs will break except if you want to glue them!
• Multicolor: print each color group separately, or use AMS / manual filament swap