Large Propagator

A plant propagator that lets your cuttings grow roots in water, so moving them to soil later is easy (or just to leave them as water plants, as I do).
Easy to slide the glass tube in, but once it's there the design clamps down and holds it firmly. No AI used (which is true for all my shared projects!)

Sizing

Designed for glass tubes 3.0 cm (1.18 in) in diameter
Recommended tube height: 11–18 cm (4.3–7.1 in)
Rounded base supported

Any tube with these dimensions will work, but here is an affiliated link if you want to further support me: Example Tube

This model is forgiving on tolerances, so a little variation in your tube won't trip it up. Using tubes with a rounded bottom? You're covered. There's a curve built into the base for snug contact and no slippage.

Filament
PETG is highly recommended as it holds up better against light and heat the model will face (direct sunlight at your window)

I also have two other smaller propagator models in case this is too big for what you are looking for.

Descrição