Charizard & Mewtwo Hueforge & Frame

Charizard & Mewtwo (250x200mm with Frame)

This Hueforge uses Bambu PLA Basic!
(Other brands may not give the same results)

Charizard (230x180mm)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Start with Brown
At layer #6 (0.56mm) swap to Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Purple
At layer #15 (1.28mm) swap to Red
At layer #16 (1.36mm) swap to Jade White
At layer #19 (1.6mm) swap to Red
At layer #21 (1.76mm) swap to Sunflower Yellow
At layer #23 (1.92mm) swap to Jade White for the rest.

Mewtwo (230x180mm)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Start with Brown
At layer #6 (0.56mm) swap to Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Purple
At layer #15 (1.28mm) swap to Red
At layer #16 (1.36mm) swap to Jade White
At layer #19 (1.6mm) swap to Red
At layer #21 (1.76mm) swap to Sunflower Yellow
At layer #23 (1.92mm) swap to Jade White for the rest.

Explosion
This is glued onto the hueforge.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Start with Black
At layer #8 (0.72mm) swap to Red
At layer #17 (1.44mm) swap to Sunflower Yellow
At layer #23 (1.92mm) swap to Jade White for the rest.

For reference aligning the explosion to the divider (the divider will have two bits that may need gluing as they are small.

Head over here to get the correct frame!

Descrição