Snap-on cable clip that holds a cable or bundle in a rounded channel and snaps shut to keep it in place. Pick the mount that fits your surface: edge clip, screw down foot, push-in pin, or flat adhesive base.
 

The main feature is the Customizer. Set your own cable diameter, snap opening, clip width, panel thickness, screw size, and pin size, then download a clip made exactly for your job. No remixing needed.
 

Every clip prints flat with no supports in the orientation it is generated. Layer lines follow the channel curve for a clean snap and a strong hold.

• One clip weighs about 1 to 2 grams. 
• One clip prints in about 5 minutes.
• One plate of 4 clips prints in about 20 minutes and uses about 4 to 8 grams.
• No supports required.
• Suggested material: PLA or PETG. PETG gives a more flexible, durable snap.
• Suggested settings: 0.2 mm layer height, 3 walls for a firm grip.

Mount Types

• Edge clip, cable along the edge: slides onto a panel, shelf, or desk edge, cable runs parallel to the edge
• Edge clip, cable across the edge: same grip, cable crosses the edge at 90 degrees.
• Screw mount: flat foot with a screw clearance hole.
• Push pin mount: barbed pin that snaps into a drilled hole.
• Adhesive base: flat base for double-sided tape or free standing.

How to use 

1. Use the Customizer to set your cable size and mount, or pick a ready print profile below.
2. Print flat, no supports.
3. Snap the cable into the channel and fix the clip to your surface.