All of the prints I print to make sure they look good. Some of the times with hue forge they can come out a little discolored because of the transmission distance. I would strongly recommend the colors that I am using to really get the best effect.

They are 200x200 and fit standard frames. Allot of my prints are thicker and don’t really need a frame for them. I just usually print a hanging tab for the back and glue it on. This was printed inverted and love the way it came out. I plan to upload the regular version later.

All instructions are included

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.64mm
The Max allowed Thickness is 2.64mm and the Actual Thickness is 2.64mm

    PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
    PLA BambuLab Basic Sunflower Yellow  Transmission Distance: 4.4
    PLA BambuLab Basic Mistletoe Green  Transmission Distance: 1
    PLA BambuLab Matte Scarlet Red  Transmission Distance: 2
    PLA BambuLab Basic Cobalt Blue  Transmission Distance: 1.2
    PLA BambuLab Basic Light Gray  Transmission Distance: 1.7
    PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
This print uses 7 unique filaments

Swap Instructions:
    Start with Ivory White
    At layer #10 (0.88mm) swap to Sunflower Yellow
    At layer #13 (1.12mm) swap to Mistletoe Green
    At layer #18 (1.52mm) swap to Scarlet Red
    At layer #22 (1.84mm) swap to Cobalt Blue
    At layer #27 (2.24mm) swap to Light Gray
    At layer #29 (2.4mm) swap to Charcoal for the rest.