Want to sell my prints? Commercial License now available here: [https://patreon.com/3ReePrinting](https://patreon.com/3ReePrinting)

You can check out the rest of my Pokémon series here: [https://makerworld.com/@3ReePrinting/collections/2982999](https://makerworld.com/@3ReePrinting/collections/2982999)

Final Evolution in the Squirtle line! Hope you're enjoying these as much as I am enjoying making them!

Basic Cyan = Glow Blue & Matte Yellow = Glow Yellow for the glow effect

This print is the maximum build plate size for an A1 Mini, but it should work on any printer.

If you resize the model make sure you do NOT scale the Z axis or the print colors will not be in the same position

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 170x170mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.16mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #00358e PLA BambuLab Basic Blue  Transmission Distance: 4
    #0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 3.5
    #ffffff PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
    #de4343 PLA BambuLab Matte Scarlet Red  Transmission Distance: 2
    #ffe17f PLA BambuLab Matte Lemon Yellow  Transmission Distance: 4
    #d1d3d5 PLA BambuLab Basic Light Gray  Transmission Distance: 1.7
This print uses 7 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Blue
    At layer #11 (0.96mm) swap to Cyan
    At layer #15 (1.28mm) swap to Ivory White
    At layer #16 (1.36mm) swap to Scarlet Red
    At layer #17 (1.44mm) swap to Lemon Yellow
    At layer #20 (1.68mm) swap to Light Gray
    At layer #22 (1.84mm) swap to Ivory White for the rest.