“…so UGlies, be careful what you swim for, or you might lose your cosmetics to its crazy bite!” 

- Dinodex, official UG Discord.

Mosasugus - Hydro Titan 01

The Mosasugus is a fearsome beast that lives in the depths of UG's water map.

The only known way of defeating it? Aim for the mouth.

The Mosasugus is a bit different from the other dinos, as there's a special assembly for the mouth.

*Disclaimer: the mouth is floppy rather than poseable.

To assemble the mouth, take the bottom jaw and firmly push it into the head, a diagonal angle works best.

The goal is to slightly bend the head prongs outwards so you can fit the jaw inside.
It takes a few tries (and maybe a few minutes of struggling), but it'll work!

Don't get discouraged if you can't do it immediately!

Kids, try getting help from an adult if you're having trouble…

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking.
* DON'T USE IT!

You might need clippers to remove or clean up some of the small supports, but most of them can be taken off normally.

Please leave the parts in their current orientations, they're arranged for best printing of the sockets.

I would recommend sanding or smoothing down rough edges on the joints if you have difficulty fitting them together. (Like on the tiny flippers).

Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)