MINI UPSIDE-DOWN BOWLING!

This set is lots of fun for everybody.

The bowling pins are held by magnets but are knocked down when the ball hits them.

Inserting the magnets is simple, use the 3mf files build in pauses, wait for the pauses then put the magnets in.

If you use different slicer than Bambu studio, just make sure the pause (make your own) happens after the last layer of the hole.

The magnets (5x2mm) are from the makers supply, and you can buy them above, the filament is optional, but it is there if you want it (you can use any color).

There is a print profile for the bowling lane and ball and one for the pins.

(The bowling pins/pin print profile is the same as my mini bowling)

Contains small parts: Recommended 3 years and older