This is my fully customized FIREBALL EMBLEM. This emblem was designed to be in a car or vehicle, so has been printed in PETG.

The sharp corners and organic shape has forced some very fine lines, especially at the current size. The included profile has all of the required settings, but please make note:

Since this is in PETG, make sure your filament is dry and tuned in! This was made with SUNLU PETG, but I will also include similar colors from Bambu as part of the part list. Walls have been reduced down to 1. This is because of how fine the lines are around each color. Any more than 1 wall and the infill will not be able to cover the entire color section!

I also have ironing turned on - To get a smooth top surface finish on every color, this is very important. My ironing settings may not be best for the PETG you are using! I have dialed in my filament specifically for my P1S, use my ironing settings with causion!

For SUNLU PETG and my Matter3D Performance PETG, these ironing settings worked the best, specifically for this model:

I highly recommend using your own ironing settings, for the filaments that you have already dialed in. 

Please also be sure to keep the wall generator setting to Arachne. As mentioned a few times, the edges of the flames for each color are very fine lines - if this is not set to Arachne, then the tips of the flames will not get sliced correctly!

I hope you enjoy this customized emblem - If you are having troubles printing this or have questions, please let me know!