Can you print this model with your usual routine?
 

As a creator here on Makerworld I see lots of print fails and a majority is due to people not cleaning their plate.
Bambu advises not to use alcohol on their build plates and many people take this by heart and use soap and water.

While its safe, its tedious and error prone.
If you leave the slightest hint of soap on your build plate adhesion is worse than before.

Glue is not for better adhesion!
Its a release agent to make parts stick LESS.
If its helping your parts stick its masking the greasy finger prints you dont clean off your plate.

After more than 10 years of 3D printing my go to is isopropyl alcohol.
You spray your bed even in the printer and just wipe it off taking the grease from touching the plate with it.
IPA is used in all industries, from medical, over painting, electronics etc. to clean and degrease while being plastic safe.
Takes less than 5 seconds, doesnt leave any residue, dont need to walk to the sink, and works without fail.

A spray bottle and a dedicated wiper make it super convenient.

Let me know in the comments why you keep using soap and water!

 

Powered by MakerWorld-Make My Sign (https://makerworld.com/makerlab/makeMySign)