“They say with age comes wisdom. The Unk does not believe in that philosophy, instead following something along the lines of - tail, smash, tail -” 

- UG Dinodex

Unkylosaurus - Hunter 10

The Unkylosaurus from UG VR.

Likes to smash various household items with its tail. Be careful.

You might need clippers to remove some of the small support bits, but most of them should separate easily.

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking.
* DON'T USE IT!

Please leave the parts in their current orientations; they might require extra supports, but they are arranged for best  printing of the sockets.

Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)

I would recommend sanding or smoothing down rough edges on the joints if you have difficulty fitting them together.