After coming out I designed this customizable hanging wavy pride flag, The NON AMS and WITH AMS instructions assume its the rainbow flag, but should still work with other flags.

TO PRINT FLAG INSTRUCTIONS:

NON AMS: Have your printer do a pause command every 20mm(or your own desired heights) and manually change the filament each time.

WITH AMS: I have included a pre painted rainbow model where the first two and last two colors are the same. Once it finishes printing the first two colors(ex. purple/blue) swap them out with the correct colors like orange red for example, no need to stop print at all. this just makes it simpler to print

TO PRINT HANGER INSTUCTIONS:

 print it on its long flat section(no supports). I used ABS with gyroid infill, But I'm sure PETG Should be just fine.

ASSEMBLY INSTRUCTIONS:

>Once the flag and hanger are printed you will need some(4) S hooks and some small Chain as linked below.

>Screw the hanger into the wall using the two 5mm screw holes.

>Cut two pieces of chain to equal length.

>Attach a S hook to both ends of each of the chains.

>Hook the chain Into the rectangular holes on the flag top and the rings of hanger.

>Congrats you are finished here's  your cookie 🍪

CHAIN [ [https://www.amazon.com/dp/B0D1XGQ65V?ref_=ppx_hzod_title_dt_b_fed_asin_title_0_0&th=1](https://www.amazon.com/dp/B0D1XGQ65V?ref_=ppx_hzod_title_dt_b_fed_asin_title_0_0&th=1)  ]

S HOOKS [ [https://www.amazon.com/dp/B09NTKL4ZK?ref_=ppx_hzod_title_dt_b_fed_asin_title_0_1&th=1](https://www.amazon.com/dp/B09NTKL4ZK?ref_=ppx_hzod_title_dt_b_fed_asin_title_0_1&th=1) ]