Floating Shelf

A simple, modern floating shelf designed for lightweight items and easy assembly.

Important Printing Notes

⚠️ Your print bed must be completely clean before printing. Any dust, oils, fingerprints, or leftover residue can reduce bed adhesion, causing the print to warp. Because of the size of the parts, even minor warping can lead to print failure.

For best results:

• Clean the build plate thoroughly before printing.
• Ensure proper first-layer adhesion.
• Avoid touching the print surface after cleaning.

Weight Capacity

⚠️ This shelf is 3D printed and is not designed for heavy loads. It is intended for lightweight decorative items only. Excessive weight may cause deformation, failure of the printed parts, or damage to the wall mount.

Assembly Instructions

Step 1

Insert the small dowel into the hole on the main shelf component.

Step 2

Attach the second side piece by aligning it with the exposed end of the dowel and pressing the parts together.

Step 3

Secure the wall mounting piece to the wall using screws.

Important: If mounting to drywall, use appropriate drywall anchors. Installing screws directly into drywall without anchors can cause the mount to pull out of the wall.

Step 4

Slide the fully assembled shelf onto the wall-mounted bracket until it is fully seated.

Disclaimer

Always verify that your wall surface and mounting hardware are appropriate for your application. The designer is not responsible for damage caused by improper installation, excessive loading, or misuse