Bambu Lab Hydrometer Stand

Hi! I recently ordered a Bambu Lab Hydrometer and decided to make a stand for it so it is easy to see and accessibly.

I recommend ordering using the link below as it helps you check the humidity as if it is too high, the printer will absorb the water, causing bad prints. This can be easily prevented by using silica gels or vacuum sealing your filaments after use.

The print uses 12.84g of filament and takes 57min 34sec.

The model requires no supports or AMS..

Gyroid Infill and increased wall loops for increased Strength.

0.2mm Layer height.

Click on my profile to see the other models I have made.

Please like, rate and follow me.

Feel free to leave a comment if you want a variation or an improvement.

Thankyou for looking at my model!

Descrição