1️⃣ A card box for the game SEQUENCE, using the parametric model by Layer51 with text added to the lid.

2️⃣ Tubes to hold the counters/chips from the game, noting there are 50 🟢, 50 🔵 and only 35 🔴, using the parametric model by NC Labs, adjusted for height and with matching knurling. The tubes have a 5mm centre hole at the bottom to allow for air so chips don't get stuck.

I printed another Sequence Box and it was a very small amount too snug for the cards in my set, I could have resized the dimensions but they were already at different percentages and I didn't want to have to adjust a few times to allow for expansion of the insert as well as the empty space I needed, so I just modified the Snap Box by Layer 51.

All parts fit back in the original box, if you put the cards under the centre ridge of the box.  I printed this for a friend as well who has put the cards, chips and the board all into a large flexible zip up pencil case to take up less space in his camper and to keep all the elements together and free from damage.