A customizable no-support soundbar riser with an architectural arch design. Measure your soundbar, adjust the parameters, and print your perfect stand.

I was honestly tired of seeing my soundbar simply sitting flat on the TV cabinet.

It worked, of course, but visually it always felt unfinished: the soundbar was there, but it looked like it was just placed there without intention. I wanted something that could lift it slightly, give it more presence, and add a bit of style and design to the whole TV setup.

So I designed this parametric soundbar support.

The idea is simple: measure your soundbar, adjust the parameters, generate the version that fits your setup, and print it. The support is built with a clean architectural shape: a lower curved arch that gives the object a more designed look, and a flat upper shelf where the soundbar rests safely between a rear lip and a smaller front lip.

Because this is a parametric model, you can customize the main dimensions directly from the generator. You can adjust the support depth, the width of the printed piece, the height of the lips, the visible width of the arch, the arch radius, and even add extra height without deforming the curved shape.

Even if I designed it specifically as a soundbar stand, the code can actually be used for many other purposes. By playing with the settings, you can generate small raised platforms, display stands, risers, holders, or any kind of support surface where something needs to be lifted and displayed with a little more style.

Print it in the same orientation generated by the model. No supports are needed.

You can choose the level of detail and finish depending on your needs. The versions shown in the photos were printed in Extra Draft mode, and the only special touch was using two different filaments to create a nice contrast. Even with very fast settings, the result is still a clean and stylish design object.

Customizable parameters

You can adjust:

• support width
• soundbar support depth
• shelf thickness
• arch radius
• visible arch width
• arch position
• extra height
• rear lip height
• front lip height
• edge rounding
• curve quality

Printing tips

Print orientation: as generated
Supports: not required
Recommended material: PLA, PETG, PLA Matte, PLA Silk or other decorative filaments
Infill: 10–20% is usually enough
Wall loops: 2 or more
Layer height: from Extra Draft to Fine, depending on the finish you want

extra; For the best visual result, try printing a pair of supports with a contrasting filament or a matte material. A simple material choice can completely change the final look and make the stand feel much more like a real design accessory than a basic utility part.

Notes

!!!!!Measure the depth of your soundbar before generating the model!!!!! 

!!!add some mm of spacing for seafty!!!

For longer soundbars, print two supports and place them near the left and right sides. For heavier soundbars, consider increasing the support width, wall loops, and infill percentage.

This model is not limited to soundbars: it can also be used as a small riser, display stand, shelf support, decorative platform, or base for other objects.