Adjustable Clothes Peg

I designed this clothespin for hanging clothes on railings with pipe diameters of approximately 28 mm.

The adjustable design also works well on both smaller and larger diameters, ranging from about 8 mm to 35 mm.

Print time for one complete unit is approximately 30 minutes. No supports needed.

Recommended Materials

The best results have been achieved with:

• PLA Matte
• PLA+
• PETG HF

PETG Basic is not recommended, as it is both more slippery and less rigid than the materials listed above. PETG Translucent works reasonably well.

Outdoor Use

For outdoor use, light-colored filaments are recommended. White is ideal, as it absorbs less heat from direct sunlight and helps reduce the risk of deformation on hot days.

Tip

The ring is optional. The peg can be used with or without it, depending on your preference.

Assembly instructions in pictures.