Ladybug fridge magnet 

Based on the iconic ladybug from the game Animal Jam Classic. 

Print at 100% infill with a layer height of 0.2mm and base layer as well. AMS is needed for print. Magnet will be used for this model, 8x2mm magnet works the best, (can find magnets at Bambu's store if needed) can use other magnet sizes but negative part within the model will need to be adjusted for your chosen magnet. But 8x2mm is my recommendation, fits perfectly in the eye of the ladybug. Anything bigger may effect the quality of the print. 

Filament used: 

• PLA Black 
• PLA Grey
• PLA Red 
• PLA White

Magnet & instructions: 

• 8x2mm magnet
• put a pause in the G-Code at layer #12 (2.40mm)
• put magnet in the negative part located in the eye 
• once done, continue on with the print

The two antennas of the ladybug are very delicate, especially the left one. I've added a part to support it. Be careful with removing the completed print from the build plate and build plate has been cooled.