Protective cap designed for the Geberit Quick Release WC seat button.

This cover helps prevent accidental button presses by children and protects the internal hinge mechanism from:

• water,
• cleaning chemicals,
• humidity,
• urine exposure,
• everyday bathroom moisture.

Over time, these conditions can cause oxidation or corrosion inside the quick release mechanism.
This cap acts as a simple protective barrier while maintaining a clean and minimal appearance.

The model installs without screws or glue and snaps securely onto the original button.

Features

• Snap-fit installation
• No glue required
• No screws required
• Easy to remove
• Helps prevent accidental button presses
• Protection against moisture and cleaning liquids
• Minimalistic design
• Printable without supports
• Bathroom-friendly functional print

Compatibility

Tested with:

• Geberit Quick Release hinge 893.278.00.0
• H011E

May also fit similar Geberit hinge models.

Recommended Print Settings

Material

Recommended:

• PETG (best choice for bathroom environments)

Also works with:

• PLA
• ASA

Print Settings

• Layer height: 0.20 mm
• Walls: 4
• Infill: 20–30%
• Supports: No
• Brim: No

Why PETG?

PETG is recommended because it offers:

• better moisture resistance,
• improved temperature resistance,
• slightly flexible snap-fit behavior,
• better long-term durability in humid environments.

PLA works fine as well, but PETG is preferred for long-term bathroom use.

Installation

1. Align the cap with the original button.
2. Press gently into place.
3. The cap snaps over the button edge.
4. Remove by hand if needed.