Modular Hotwheels Display Stand

Hello!

The model consists of 3 base pieces, left, middle and right. The minimum size is 3 pieces, one of each, but you can print as many middle pieces as you want!

Everything prints separately, there are a few colors changes on the parking lines and on the hotwheels logo, but they are in height, so only one color change per color is required!

 

Assembly:

Base Left(red), Base Middle(red) and Base Right(red) slot into each other using their connectors, they cannot be slotted in in a wrong orientation, so as long as it fits, it's good!

Place Parking Lines into the bottom of the Bases to have slots for each individual car! They, again, cannot be slotted in a wrong orientation, so as long as it fits, it's good!

If going for multiple levels, grab 1 piece of each connector, they slot into the top of the Red Bases.

NOTE: The middle connector slots into the top of Base Middle with the smaller connectors, the bigger connectors are supposed to be on top!

After slotting in all the connectors into the top of the bases, connect another set of all the Red Bases (Right, middle and left) and position them so they slide into the top of the connector pieces!

Depending on how well the tolerances come out of your printer, you may need a bit of glue on the connectors so the stand doesn't bow forward, causing the cars to slide forward. If that's the case, put a bit of glue into the Red Base connector holes, so the stand sits straight with now bowing.