Simple Filament Clip

The Best Universal Filament Clip – Stop the Tangle!

Tired of loose filament ends unwinding, creating hidden tangles, or snapping off on the spool rim? Meet the ultimate solution for spool management. This clip was engineered from the ground up to be ultra-secure, completely universal, and incredibly quick to print. No more struggling with clips that snap after three uses.

Why This Is The Last Filament Clip You’ll Ever Print

No Threading Required: Just push the filament into the side slot with your thumb and it locks tight.

Truly Universal Fit: Works flawlessly across almost every major brand—Bambu Lab (plastic & cardboard spools), Sunlu, eSun, Polymaker, Overture, and more.

Built to Last: Reinforced stress points mean it can bend repeatedly without snapping.

For the absolute best results, please use the "Simple Filament Clip" Print

Profile

Setting	Recommended Value
Layer Height	0.20mm (Standard)
Walls / Perimeters	2 walls (for maximum spring durability)
Infill	5% - 10%
Supports / Brims	NONE (Print and go!)
Best Materials	PETG / ABS / ASA (Best long-term spring retention) PLA works too, but may be more brittle

⚠ Standard AMS Note: This clip is designed for tidy storage, external spool holders, and the AMS Lite. Because it hugs the outer rim, it may cause clearance issues on the internal rollers of a standard, closed AMS unit if left attached during a print. Remove before loading into the AMS!

🚀 Show Your Support!

If this clip saves you from a single failed print or tangled nightmare, please consider:

Giving it a ⭐⭐⭐⭐⭐ rating.
Uploading a photo of your print.

Descrição